Body Electrical System
Repair procedures
In this manual: Body Electrical System
9steps
~54min
2/5difficulty
Done 0 of 9
Diagnosis With KDS/GDS
BSD system defects can be quickly diagnosed with the KDS/GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis.
Connect the cable of KDS/GDS to the data link connector in driver side crash pad lower panel, and turn on the KDS/GDS.
Select the vehicle model and then BSD system.
Select "Input/output monitoring", if you want to check current data of BSD system.

If you want to check each module operation forcefully, select "Actuation test".

Ignition "OFF", connect KDS/GDS.
Ignition "ON” & Engine "OFF", select BSD system and "BSD Radar Calibration" mode.

The KDS/GDS will show the BSD Reset function steps.
Erase BSD diagnostic codes.
BSD initialization.


The BSD initialization procedure will be performed.

Was this page helpful?