Body Electrical System
Blind Spot Detection Unit Repair procedures
In this manual: Body Electrical System
8steps
~48min
3/5difficulty
Done 0 of 8
Removal
Disconnect the negative (-) battery terminal.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
Disconnect the BSD connector (A).

Remove the BSD unit (A) after loosening the mounting nuts.

Installation
Place the RH and LH radar sensors on each side to get ready for installation.
Install the radar sensor to the bracket correctly (distinguish RH & LH) with mounting nuts.
Install the rear bumper cover.
Connect the negative (-) battery terminal.
Was this page helpful?