Hybrid Control System

DC Fuse Repair procedures

12steps
~72min
5/5difficulty
010203040506.95N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Removal

  1. Shut off the High Voltage circuit.

    (Refer to Hybrid Control System - “High Voltage Shutoff Procedure”)

  2. Remove the air cleaner and air duct.

    (Refer to Engine Mechanical System - "Air Cleaner")

  3. Disconnect the power cable (A) and inverter power cable (B).

  4. Remove the DC fuse cover (B) after loosening the mounting hexagon head bolts (A).

    DC Fuse cover mounting hexagon head bolt :

    4.9 - 6,9 N·m

  5. Remove the seal cover (B) using pliers (A).

  6. Remove the DC fuse (A) after loosening the mounting bolts.

    DC Fuse mounting bolt : 9.3 - 10,4 N·m

Installation

  1. Install the DC fuse in the reverse order of removal.

Inspection

  1. Shut off the High Voltage circuit.

    (Refer to Hybrid Control System - “High Voltage Shutoff Procedure”)

  2. Remove the air cleaner and air duct.

    (Refer to Engine Mechanical System - "Air Cleaner")

  3. Disconnect the power cable (A) and inverter power cable (B).

  4. Remove the DC fuse cover (A) after loosening the mounting hexagon head bolts.

    DC Fuse cover mounting bolt : 4.9 - 6,9 N·m

  5. Remove the seal cover (B) using pliers (A).

  6. Check the continuity between ends of the DC fuse.

    Specification : Less than 1Ω [20 °C]