Engine Mechanical System

Drive Belt Repair procedures

4steps
~24min
2/5difficulty
Done 0 of 4

Removal

  1. Remove the engine room under cover.

    (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")

  2. Remove the drive belt.

    1. Using the wrench, turning the mechanical tensioner (A) counterclockwise and then insert a stopper pin (B) into the hole.

    2. Install the SST (09244 - G2100) to hydraulic tensioner (A) and then compress the hydraulic tensioner by tightening the adjusting bolt (B).

    3. Remove the drive belt (A).

Installation

  1. Install the drive belt.

    1. Install the drive belt (A).

    2. Remove the SST (09244 - G2100) from the hydraulic tensioner (A) by loosening the adjusting bolt (B).

    3. Using the wrench, slightly lift the mechanical tensioner (A) and then remove the stopper pin (B). Slowly place the mechanical tensioner (A).

  2. Install the engine room under cover.

    (Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")

Inspection

Visually check the belt for excessive wear, frayed cords etc. If any defect has been found, replace the drive belt.