Service Highlight

Hybrid Drive Motor Assembly Repair procedures

10steps
~60min
3/5difficulty
0102030405026.520N·mlb·ft
Tightening torque found on this page
Done 0 of 10

Inspection

  1. Inspect the resistance line to line using mΩ tester.

    Item Inspection area Specification Remarks
    Phase-to-phase resistance Pins U - V 36.0 mΩ ± 5 % Deviation in phase-to-phase resistance at room temperature 68°F (20°C): 5%
    Pins V - W
    Pins W - U

  2. Inspect the temperature sensor resistance.

    Item Inspection area Specification Remarks
    Resistance (Temperature sensor) Pins 4 - 8 10.92 - 13.44 kΩ At room temperature 68°F (20°C)

  3. Inspect the resolver sensor resistance.

    Item Inspection area Specification Remarks
    Resistance
    (Resolver sensor)
    Pins 1 - 5 11.7 Ω ± 10 % At room temperature 68°F (20°C)
    Pins 2 - 6 34.5 Ω ± 10 %
    Pins 3 - 7 29.5 Ω ± 10 %

  4. Inspect the insulation resistance.s

    Item Inspection area Specification Remarks
    Insulation
    (housing, cover)
    Motor Pin U - GND
    Pin V - GND
    Pin W - GND
    10 MΩ↑ DC 540 V, 1 minute
    2.5 mA↓ AC 1600 V, 1 minute
    Resolver sensor Pin 1 - GND
    Pin 2 - GND
    Pin 3 - GND
    10 MΩ↑ DC 500 V, 1 minute
    Temperature sensor Pin 4 - GND 10 MΩ↑

Removal

  1. Remove the hybrid drive motor & dual clutch transmission assembly from the vehicle.

    (Refer to DCT System - "DCT")

  2. Remove the engine clutch actuator (A).

    Tightening torque : 21.6 - 26 N·m

  3. Remove the concentric slave cylinder.

    (Refer to Clutch System - "Concentric Slave Cylinder Assembly")

  4. Remove the hybrid drive motor (A) loosening the bolts.

    Tightening torque : 42.2 - 54 N·m

Installation

  1. Install in the reverse order of removal.

  2. Perform the procedure below after installing.

    1. Refill the hybrid motor cooling system with coolant and then perform the air bleeding using the KDS/GDS.

      (Refer to Hybrid Motor System - "Coolant")

    2. Perform initialization of the engine clutch inspection line learning and diagnostic information using the GDS.

    3. Refill the engine clutch reservoir with brake fluid and then perform the air bleeding using the KDS/GDS.

    4. Perform the engine clutch / motor resolver adaptation using the KDS/GDS.

    5. Perform of the stabilization of the engine clutch hardware transfer torque using the GDS.