Body Electrical System
Memory power seat switch Repair procedures
In this manual: Body Electrical System
8steps
~48min
2/5difficulty
Done 0 of 8
Removal
Disconnect the negative (-) battery terminal.
Remove the driver front door trim.
(Refer to Body - "Front Door Trim")
Remove the memory power seat switch (A) after loosening the mounting screws.

Installation
Install the memory power seat switch (IMS).
Install the driver front door trim.
Connect the negative (-) battery terminal.
Inspection
Remove the memory power seat connector.

When each switch is pressed, check the electricity flow between memory power seat switch connector and grounding, and if the electricity does not match the specification, replace the switch.

Was this page helpful?