Service Highlight

Power Relay Assembly (PRA) Repair procedures

9steps
~54min
4/5difficulty
0102030405029.422N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Removal

  1. Shut off the high voltage circuit.

    (Refer to Hybrid Control System - “High Voltage Shutoff Procedure”)

  2. Remove the rear seat cushion.

    (Refer to Body - "Rear Seat Assembly")

  3. Remove the rear door scuff trim.

    (Refer to Body - "Door Scuff Trim")

  4. Remove the cooling duct.

    (Refer to High Voltage Battery Cooling System - "Cooling Duct")

  5. Remove the upper frame (A) after loosening the mounting bolts and nuts.

    High voltage battery system assembly upper frame mounting bolt :

    19.6 - 29 N·m

    High voltage battery system assembly upper frame mounting nut (M8) :

    19.6 - 29 N·m

    High voltage battery system assembly upper frame mounting nut (M6) :

    7.8 - 11,8 N·m

  6. Remove the high voltage battery rear cover (A) after loosening the mounting bolts and nuts.

    High voltage battery rear cover mounting bolt / nut :

    7.8 - 11,8 N·m

  7. Disconnect the high voltage power cable [+] (A) and high voltage cable [-] (B) after loosening the mounting bolts.

  8. Disconnect the BMS ECU extension connector (A), battery current sensor connector (B), inverter power connector [-] (C), inverter power connector [+] (D) and , PRA connector (E).

  9. Remove the power relay connector after loosening the mounting nuts (A).

    Power relay assembly mounting nut :

    7.8 - 11,8 N·m

Installation

  1. Install the power relay assembly in the reverse order of removal.