Brake System
Rear Wheel Speed Sensor Repair procedures
In this manual: Brake System
5steps
~30min
2/5difficulty
Done 0 of 5
Removal
Remove the tire.
Disconnect the wheel speed sensor connector (A).

Loosen the bearing bolts (A) and then remove the hub bearing assembly.
Tightening torque: 88.2 - 108 N·m

Inspection
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.

Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low : 0.59V - 0.84V V_high : 1.18V - 1.68V Frequency range : 1 - 2,500Hz
Was this page helpful?