Engine Electrical System

Smart Cruise Control (SCC) Switch Repair procedures

16steps
~96min
4/5difficulty
Done 0 of 16

Inspection

Measuring Resistance

  1. Disconnect the cruise control switch connector from the control switch.

  2. Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).

    Switch Terminal Resistance (±3%)
    Cancel 2 - 6 390Ω
    SET - 2 - 6 610Ω
    RES + 2 - 6 910Ω
    Cruise ON/OFF 2 - 6 1.38kΩ
    Following distance control (SCC) 2 - 6 3.63kΩ
  3. If not within specification, replace switch.

Removal

  1. Disconnect the negative (-) battery terminal.

  2. Remove the steering wheel assembly.

    (Refer to Steering System - "Steering Wheel")

  3. Remove the steering back cover (A) after loosening the mounting screws.

  4. Remove the wiring connector (A) from the steering back cover.

  5. Disconnect the steering wheel remote control connector (A).

    [LH]

    [RH]

  6. Remove the steering wheel remote control assembly (A) after loosening the mounting screws.

  7. Remove the steering wheel remote control (A) after loosening the mounting screws.

Installation

  1. Install the steering wheel remote control.

  2. Install the steering wheel remote control assembly.

  3. Connect the steering wheel remote control connector.

  4. Install the steering back cover.

  5. Install the steering wheel and driver airbag module.

  6. Connect the negative (-) battery terminal.