Heating, Ventilation and Air Conditioning

Temperature Control Actuator Repair procedures

19steps
~114min
4/5difficulty
Done 0 of 19

Inspection

  1. Switch "OFF" the ignition.

  2. Disconnect the temperature control actuator connector.

  3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.

    Verify that the temperature control actuator operates to the warm position when connected in reverse.

    Temperature control actuator [LH]

    1. -
    2. -
    3. Cool position
    4. Sensor (+ 5V)
    5. Feedback signal
    6. Sensor ground
    7. Warm position

    Temperature control actuator [RH]

    1. -
    2. -
    3. Cool position
    4. Sensor (+ 5V)
    5. Feedback signal
    6. Sensor ground
    7. Warm position
  4. Connect the temperature control actuator connector.

  5. Switch "ON" the ignition.

  6. Check the voltage between terminals 5 and 6.

    Specification

    Door Position Voltage (V) Error Detectio
    Max. cooling 0.3 ± 0.15 Low voltage : 0.1V or less
    High voltage : 4.9V or more
    Max. heating 4.7 ± 0.15

    It will feedback the current position of the actuator to controls.

  7. If the measured voltage is not within specification, substitute with a known-good temperature control actuator and check for proper operation.

  8. Replace the temperature control actuator if it is proved that there is a problem with it.

Replacement

[Driver side]

  1. Disconnect the negative (-) battery terminal.

  2. Remove the crash pad lower panel.

    (Refer to Body - "Crash Pad Lower Panel")

  3. Loosen the mounting screw and remove the cockpit shower duct (A).

  4. Disconnect the duct sensor connector (A).

  5. Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws.

  6. Install in the reverse order of removal.

[Passenger side]

  1. Disconnect the negative (-) battery terminal.

  2. Remove the glove box housing.

    (Refer to Body - "Glove Box Housing")

  3. Remove the passenger side shower duct (A) after loosening the screw.

  4. Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws.

  5. Install in the reverse order of removal.