Timing Chain Repair procedures
Removal
Shut off the high voltage circuit.
(Refer to Engine Mechanical System - “High Voltage Shut off Procedure”)
Remove the cylinder head cover.
(Refer to Cylinder Head Assembly - "Cylinder Head Cover")
Set No.1 cylinder to TDC (Top dead center) on compression stroke.
Turn the crankshaft pulley and align its groove with the timing mark of the timing chain cover.

Remove the timing chain cover.
(Refer to Timing System - "Timing Chain Cover")
Before removing the timing chain, mark the timing chain with an identification based on the location of the sprocket because the identification mark on the chain for TDC (Top Dead Center) can be erased.

Remove the timing chain cover.
(Refer to Timing System - "Timing Chain Cover")
Remove the timing chain tensioner (A).

Remove the timing chain tensioner arm (A).

Remove the timing chain guide (A).

Remove the timing chain cam guide (A).

Remove the timing chain (A).

Inspection
Sprockets, Chain Tensioner, Chain Guide, Chain Tensioner Arm
Check the CVVT sprocket and crankshaft sprocket for abnormal wear, cracks, or damage. Replace if necessary.
Inspect the tensioner arm and chain guide for abnormal wear, cracks, or damage. Replace if necessary.
Check that the tensioner piston moves smoothly.
Installation
Install the timing chain.
Crankshaft sprocket → Intake CVVT sprocket → Exhaust CVVT sprocket
Install the timing chain with no slack between the crankshaft sprocket and the intake CVVT sprocket.

Install the timing chain cam guide (A).
Tightening torque : 9.8 - 11,8 N·m

Install the timing chain guide (A).
Tightening torque : 9.8 - 11,8 N·m

Install the timing chain tensioner arm (A).
Tightening torque : 9.8 - 11,8 N·m 1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)

Install the timing chain auto tensioner (A) and remove the stopper pin.
Tightening torque : 9.8 - 11,8 N·m

Install the timing chain cover.
(Refer to Timing System - "Timing Chain Cover")
Install the cylinder head cover.
(Refer to Cylinder Head Assembly - "Cylinder Head Cover")
Add all the necessary fluids and check for leaks. Connect KDS/GDS. Check for codes, note, and clear. Recheck.