Automatic Adjustment

The driver's seat can be adjusted using the control switches located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so that you can easily reach the steering wheel, pedals, and switches on the instrument panel.

WARNING

The power seat operates with the ignition OFF.

For this reason, children should never be left unattended in the vehicle.

CAUTION

• The power seat is driven by an electric motor. Stop operating the seat as soon as adjustment is complete. Excessive operation may damage the electrical components.
• The power seat consumes a large amount of electrical power during operation. To prevent unnecessary battery discharge, do not operate the power seat longer than necessary while the engine is not running.
• Do not operate two or more power seat control switches at the same time. This may damage the seat motor or cause an electrical component malfunction.

Forward and Backward

1. Press the control switch forward or backward to move the seat to the desired position.

2. Release the switch as soon as the seat reaches the desired position.

Seatback Angle

1. Press the control switch forward or backward to move the seatback to the desired angle.

2. Release the switch as soon as the seat reaches the desired position.

Seat Cushion Height

1. Pull the front part of the control switch up to raise, or down to lower the front of the seat cushion. Pull the rear part of the control switch up to raise, or down to lower the rear of the seat cushion.

2. Release the switch as soon as the seat reaches the desired position.

Lumbar Support

The lumbar support can be adjusted by operating the lumbar support switch on the side of the seat.

1. Press the front of the switch to increase support, or the rear of the switch to decrease support.

2. Release the switch as soon as it reaches the desired position.