Kia Cee'd Quiz
Drive Shaft and Axle

Dynamic Damper Repair Procedures

In this manual: Drive Shaft and Axle
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
12steps
~77min
4/5difficulty
1special tools
Done 0 of 12

Replacement

  1. Remove the front drive shaft. (Refer to Drive Shaft Assembly - "Front Drive Shaft")
  2. Remove the TJ joint assembly. (Refer to Drive Shaft Assembly - "TJ Joint")
  3. Remove both dynamic damper bands (B) from the dynamic damper (A).
  4. Secure the drive shaft (A) in a vise (B), as shown in the illustration.
  5. Apply soapy powder to the shaft to prevent damage between the shaft splines and the dynamic damper when the dynamic damper is removed.
  6. Carefully separate the dynamic damper (A) from the shaft (B).

Installation

  1. Apply soapy powder to the shaft to prevent damage between the shaft splines and the dynamic damper.
  2. Install the dynamic damper.
  3. Install the dynamic damper band (A).
  4. Using SST (09495-3K000), secure the TJ boot bands (B).

    Clearance (A): 2.0 mm (0.079 in) or less

  5. Install the TJ joint assembly. (Refer to Drive Shaft Assembly – "TJ Joint")
  6. Install the front propeller shaft. (Refer to Drive Shaft Assembly - "Front Drive Shaft")

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.