Kia Cee'd: Propeller Shaft Assembly / Front Propeller Shaft Repair Procedures

Replacement

1
Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2
Remove the front wheel and tire (A) from the front hub.
Tightening torque: 88.2 - 108 N·m

CautionBe careful not to damage the hub bolts when removing the rear wheel and tire (A).
3
Remove the drive shaft lock nut (A).
Tightening torque: 274.4 ~ 294 N·m N·m (28.0 ~ 30.0 kgf·m, 202.4 ~ 217.0 lbf·ft)

CautionThe propeller shaft staking nut must be replaced with a new one. After installing the propeller shaft staking nut, stake the staking nut using a chisel and hammer, as shown in the illustration below.
4
Using SST (09568-34000), disconnect the tie rod end ball joint (C) from the steering knuckle.
1. Remove the cotter pin (A).
2. Remove the castellated nut (B).
3. Use SST (09568-34000).
  Tightening torque: 23.5 ~ 33 N·m
  Caution
  - When using SST, be careful not to damage the lower arm ball joint dust cover.
  - Keep the SST tied to the vehicle, as there is a risk of injury if the SST falls during removal of the lower arm ball joint.
  - Peripheral parts may be damaged if the lower arm ball joint is removed using a general tool such as a pry bar. Be sure to use the SST.
5
Remove the lower arm (A) from the steering knuckle.
Tightening torque: 98.0 ~ 118 N·m
6
Using a plastic hammer, disconnect the propeller shaft (A) from the axle hub (B).
7
Loosen the inner shaft mounting bolt (A). (T-GDI engine only)
Tightening torque: 49.0 ~ 64 N·m
8
Insert a pry bar (A) between the transaxle case and the joint housing, and separate the drive shaft (B) from the transaxle case.
9
Install in the reverse order of removal.