Kia Cee'd Quiz
Body Electrical System

Power Window Switch Repair Procedures

In this manual: Body Electrical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
8steps
~48min
2/5difficulty
Done 0 of 8

Inspection

Main Power Window Switch Inspection
  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door trim panel. (Refer to Body - "Front Door Trim")
  3. Disconnect the connector from the switch.
  4. Check the continuity between the terminals at each switch position according to the table. If continuity is not as specified, replace the switch. [4-Door Full Auto (LHD)]
    [4-Door Full Auto (RHD)]
    [2-Door Full Auto (LHD)]
    [2-Door Full Auto (RHD)]
    [2-Door Auto Down (LHD)]
    [2-Door Auto Down (RHD)]
  5. Disconnect the negative (-) battery terminal.
  6. Remove the front door trim panel. (Refer to Body - "Front Door Trim") Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
  7. Disconnect the connector from the switch.
  8. Check the continuity between the terminals at each switch position according to the table. If continuity is not as specified, replace the switch. [Up/Down Safety]
    [Manual Down]
Inspection of Passenger / Rear Window Switch

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.