Kia Cee'd Quiz
Restraints

Repair Procedures

In this manual: Restraints
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
15steps
~90min
4/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 15

Removal

  1. Disconnect the negative battery cable and wait at least thirty seconds before starting work.
  2. Remove the lower anchor bolt.
  3. Remove the center pillar trim. (Refer to Body - "Center Pillar Garnish")
  4. Remove the upper anchor bolt.
  5. Disconnect the seat belt pretensioner connector (A).
  6. Loosen the seat belt pretensioner mounting bolts (B, C) and remove the seat belt pretensioner.

Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the negative battery cable and wait at least thirty seconds.
  3. Install the seat belt pretensioner using the bolts (B, C).

    Tightening torque Bolt B: 39.2 ~ 54 N·m

  4. Connect the seat belt pretensioner (BPT) connector (A).
  5. Install the upper anchor bolts.

    Tightening torque: 39.2 ~ 54 N·m

  6. Install the center pillar trim. (Refer to Body - "Center Pillar Garnish")
  7. Install the lower anchor bolts.

    Tightening torque: 39.2 ~ 54 N·m

  8. Connect the negative battery cable.
  9. After installing the seat belt pretensioner, check the system operation:
    • Turn the ignition ON; the SRS indicator should illuminate for about six seconds and then go off.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.