Kia Cee'd Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
11steps
~66min
3/5difficulty
Done 0 of 11

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the emergency pad lower panel. (Refer to Body - "Emergency Pad Lower Panel")
  3. Remove the BCM (A) after loosening the nuts.

Installation

  1. Install the BCM.
  2. Install the emergency pad lower panel.
  3. Connect the negative (-) battery terminal.

BCM Diagnosis Using GDS

  1. The Body Control Module can be diagnosed faster using GDS. The BCM communicates with GDS, then reads the input/output value and operates the actuator.
  2. To diagnose the BCM function, select the model and Body Control Module menu.
  3. Select "Input/Output Monitor" if you are going to check the current data of the body network system. It shows the input/output status of each module.
    • BCM Data, CLU Data, SJB Data
  4. If you are going to forcibly check each module data operation, select "Active Test".
  5. To change a user setting, select "User Setting".

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.