Kia Cee'd Quiz
Restraints

Repair Procedures of Side Airbag (SAB) Module

In this manual: Restraints
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
10steps
~60min
3/5difficulty
Done 0 of 10

Removal

  1. Disconnect the negative battery cable and wait at least thirty seconds before starting work.
  2. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")
  3. Remove the front seatback assembly. (Refer to Body - "Front Seat Frame Assembly")

Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the negative battery cable and wait at least thirty seconds.
  3. Install a new front seat back assembly.
  4. Install the front seat assembly. (Refer to Body - "Front Seat Assembly")
  5. Tilt and fully slide the front seat forward. Make sure the wire harness is not pinched or interfering with other parts.
  6. Connect the negative battery cable.
  7. After installing the side airbag (SAB), check that the system operates correctly:
    • Turn the ignition ON; the SRS indicator should illuminate for about six seconds and then go off.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.