Front Stabilizer Removal/Installation [Mzr 2.3 Disi Turbo]

1. Remove the joint cover..

2. Disconnect the steering shaft from the steering gear and linkage..

3. Remove the front crossmember component..

4. Remove in the order indicated in the table.

5. Install in the reverse order of removal.

6. Inspect the wheel alignment and adjust it if necessary..

1. 1

   Front stabilizer control link

2. 2

   Front stabilizer bracket

   (See Front Stabilizer, Front Stabilizer Bushing and Front Stabilizer Bracket Installation Note.)

3. 3

   Front stabilizer bushing

   (See Front Stabilizer, Front Stabilizer Bushing and Front Stabilizer Bracket Installation Note.)

4. 4

   Front stabilizer

   (See Front Stabilizer, Front Stabilizer Bushing and Front Stabilizer Bracket Installation Note.)

• Verify that the front stabilizer bushings are not caught between the front stabilizer bracket and the front crossmember, and install the front stabilizer bracket using the following procedure.

1. Temporarily tighten bolts A and B shown in the figure.

2. Tighten bolt A.

3. Tighten bolt B.

4. Tighten bolt A.