Receiver/Drier Removal/Installation

1. Disconnect the negative battery cable..

2. Discharge the refrigerant..

3. Remove the aerodynamic under cover No.2..

4. Remove the aerodynamic under cover No.1..

5. Remove the front bumper..

6. Disconnect the block joint type pipes by grasping female side of the block with hand holding firmly then loosen the connection bolt A.

7. Remove the bolt B.

8. Remove the bracket.

9. Remove the receiver/drier. Do not allow compressor oil to spill.

• If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.

10. Install in the reverse order of removal.

11. Perform the refrigerant system performance test..

1. Disconnect the negative battery cable..

2. Discharge the refrigerant..

3. Remove the aerodynamic under cover No.2..

4. Remove the aerodynamic under cover No.1..

5. Remove the front bumper..

6. Disconnect the block joint type pipes by grasping female side of the block with hand holding firmly then loosen the connection bolt A.

7. Remove the bolt B.

8. Remove the bracket.

9. Remove the receiver/drier. Do not allow compressor oil to spill.

• If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.

10. Install in the reverse order of removal.

11. Perform the refrigerant system performance test..