Mazda 6 Quiz
Body electrical system

Center panel module removal/installation

In this manual: Body electrical system
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read

1. Cancel the anti-theft operation. (with anti-theft system) (See ANTI-THEFT SYSTEM.)

2. Disconnect the negative battery cable.

3. Remove the glove compartment.

4. Remove the rear console.

5. Remove in the order indicated in the table.



6. Install in the reverse order of removal.

Caution
  • Make certain that the wiring harness and antenna feeder are not caught between the unit and dashboard. If the harness or the antenna feeder is caught between the unit and dashboard, it may cause trouble or malfunctions.

7. Operate the anti-theft system by setting the code number. (with anti-theft system) (See ANTI-THEFT SYSTEM.)

Center Panel Module Removal Note

Pull the center panel module toward you, then disengage clip A from the dashboard, and remove the center panel module.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.