Mazda 6 Quiz
Body electrical system

Instrument cluster removal/installation

In this manual: Body electrical system
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
Caution
  • When replacing the instrument cluster, the configuration procedure must be performed before removing the instrument cluster. If the configuration procedure is not performed before removing the instrument cluster, it is possible that the instrument cluster will not operate normally.

1. Configurate the instrument cluter (when only replacing it). (See INSTRUMENT CLUSTER CONFIGURATION.)

2. Disconnect the negative battery cable.

3. Pull down the adjusting lever of the tilt steering wheel and push the steering wheel down.

4. Pull the steering wheel toward you.

5. Remove the meter hood.

6. Remove in the order indicated in the table.



7. Install in the reverse order of removal.

Instrument Cluster Removal Note

When removing the instrument cluster, in order to prevent damage to the lens, cover the steering shaft with a cloth.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.