Mazda 6 Quiz
Body

Seat warmer unit inspection

In this manual: Body
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read

1. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION.)

2. Remove the seat cushion trim.

3. While inspecting for continuity between the terminals A and B of the connector, use a dryer to warm the thermostat of the seat warmer unit on seat cushion.


4. When the indication on the ohmmeter is no continuity, turn off the dryer, then use a thermometer to measure the temperature of the thermostat.


5. Verify that the temperature is approximately 29 °C {84 °F}. 6. Verify that there is continuity between the terminals of seat warmer units connector using an ohmmeter when temperature drops to approximately 20 °C {68 °F}.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.