Starting and driving

Blind Spot Warning [BSW]/Lane Change Assist [LCA]

4steps
~24min
2/5difficulty
Done 0 of 4
Mitsubishi Outlander BSW and Lane Change Assist indicators, mirror warning light and steering wheel controls
  1. Side indicator light
  2. BSW/LCA indicator (on the multi-information display)
  3. Multi-information display
  4. Steering wheel remote control switches (left side)
  • The BSW/LCA system uses radar sensors installed near the rear bumper to detect vehicles traveling beside the Mitsubishi Outlander in an adjacent lane.
  • The system operates at vehicle speeds above approximately 10 km/h.
  • If the radar sensors detect a vehicle within the monitored detection zone, side indicator light 1 in the door mirror on the corresponding side will illuminate.
  • When a vehicle is detected in the adjacent lane and the turn signal is activated toward that side, a warning buzzer sounds, BSW/LCA indicator 2 in multi-information display 3 flashes, and side indicator light 1 in the door mirror also flashes. If the radar sensor detects a vehicle approaching from behind in the neighboring lane, the Lane Change Assist [LCA] function warns the driver in the same manner.

NOTE

  • The side indicator lights illuminate for several seconds when the ignition switch is placed in the ON position.
  • The brightness of the side indicator lights is adjusted automatically according to the surrounding ambient light level.
  • The current operating status of BSW/LCA can be checked on the "Driver assistance" screen in the multi-information display.

Detection zone

Mitsubishi Outlander BSW and LCA radar detection zones on the left and right sides of the vehicle

The rear radar sensors monitor detection zones on both the left and right sides of the Mitsubishi Outlander for vehicles traveling in adjacent lanes.