Driver Information & Multimedia
Additional Service When Replacing Av Control Unit
In this manual: Driver Information & Multimedia
~1min read
Work Procedure
Description
When AV control unit is replaced, AV control unit configuration is required.
REPLACE AV CONTROL UNIT
Replace AV control unit. Refer to Removal & Installation.
>>GO TO 2
PERFORM AV CONTROL UNIT PROGRAMMING & CONFIGURATION
CONSULT
Perform AV control unit programming, according to “Replace ECU” of CONSULT Operation Manual. Refer to CONSULT Operation Manual.
Ignition switch: ON
Electric load: OFF
Brake pedal: Not depressed
12V battery voltage: 12 – 13.5 V (Check the value displayed on the CONSULT screen.)
GO TO 3
WRITE VIN DATA (AV CONTROL UNIT)
CONSULT work support
Perform “WRITE VIN (MANUAL INPUT)” to write VIN data.
>>GO TO 4
CHECK NETWORK INITIAL SETTINGS
CONSULT Work Support
Select “Work Support” of “MULTI AV” and perform “Network initial settings”.
>>WORK END
Was this page helpful?