Normal Operating Condition
Symptom Description
SYSTEM UNIT
| Symptom | Possible cause | Possible solution |
|---|---|---|
| The screen is too dark. | The cabin temperature is too low. | Wait until the cabin temperature becomes moderate. |
| The cabin temperature is too hot. | ||
| Screen brightness is set to the maximum darkness. | Adjust the brightness setting of the screen. | |
| The screen is too bright. | Screen brightness is set to the maximum brightness. | Adjust the brightness setting of the screen. |
| A small black spot or a small bright spot appears on the screen. | This is a typical phenomenon for liquid crystal displays. | This is not a malfunction. |
| A dot or stripe pattern appears on the screen. | Electromagnetic waves that are generated from neon billboards, high voltage electric power cables, ham radios or other radio devices equipped to other Nissan Armada vehicles may adversely affect the screen. | This is not a malfunction. |
| Image lag appears on the screen. | This is a typical phenomenon for liquid crystal displays. | This is not a malfunction. |
| Image motion displayed on the screen is slow. | The cabin temperature is less than 50°F (10°C). | Wait until the cabin temperature rises to within 50°F (10°C) and 122°F (50°C). |
| When looking at the screen from an angle, the screen lightens or darkens. | This is a typical phenomenon for liquid crystal displays. | Adjust the brightness setting of the screen. |
| The screen turns blue or an error message is displayed on the touch screen display. | A system malfunction has occurred. | Malfunction in AV control unit. Perform detected DTC self-diagnosis. Refer to DTC Index. |
WI-FI CONNECTION
| Symptom | Possible cause | Possible solution |
|---|---|---|
| The name of the device which you wish to connect is not displayed on the Connections screen. | The device is turned off. | Check that the device is turned on. |
| The device does not support WEP/WPA1 security network. | Check that the security network is supported by the device. | |
| The in-vehicle system cannot connect to the Wi-Fi network. | The device is turned off. | Check that the device is turned on. |
| The network password is incorrect. | Check that the network password is correct. | |
| Check the entered password is correct. |
| Symptom | Possible cause | Possible solution |
|---|---|---|
| The device cannot connect to the vehicle hotspot. | A maximum number of devices are already connected. | Delete a connected device. |
| The password is incorrect. | Check the entered password is correct. | |
| The device cannot access the Internet. | The service provider’s subscription is not active. | Check the service provider’s subscription. |
| The vehicle is out of the service area of the provider. | Move to a service supported area. | |
| Slow connectivity to the network. | Another wireless connection interferes. | Turn off the other wireless devices. |
AUDIO SYSTEM
HD RADIO TECHNOLOGY
| Symptom | Possible cause | Possible solution |
|---|---|---|
| Delay in digital audio on HD Radio broadcasts. | The radio acquires an analog station first and blends to an digital signal. | This is not a malfunction. |
| Audio skips, stutters, or echoes. | The radio station has not properly aligned the digital and analog audio. | Verify correct operation on another station. Report any station with poor performance. |
| Volume changing up/down. | The radio station has not properly aligned the digital and analog audio level. | Verify correct operation on another station and check www.hdradio.com for stations in the area. Report any station with poor performance. |
| Sound fading in and out. | The transition between analog and digital is taking place (blending). | Verify transition performance on several stations in the area. Report any stations with poor alignment. |
| Excessive blending (transition between analog and digital). | The receiver is located near the edge of the digital coverage area. | Refer to www.hdradio.com to verify radio stations in your coverage area. |
| Digital audio not better than analog audio. | Audio processing on the digital audio at a station can potentially decrease the digital audio sound quality. | Verify correct operation on another station. Report any station with poor performance. |
| Symptom | Possible cause | Possible solution |
|---|---|---|
| Keep losing my local stations. | The radio acquires an analog station first and blends to an digital signal. | This is not a malfunction. |
| Shadowing (urban/terrain) can cause reduced digital coverage. | Verify correct operation on another station. | |
| Some data fields are blank. | Text information is sent at the broadcaster’s discretion. | Verify correct operation on another station. Report station issues. |
| Text information is truncated / there appears to be more available. | The display is limited to a fixed number of characters and more data is being sent than can be shown. | This is an intended behavior. |
| AM reception changes at night. | AM stations are required by the government (FCC) to lower their power at night. | This is not a malfunction. |
iPod® PLAYER
| Symptom | Possible cause | Possible solution |
|---|---|---|
| The system does not recognize an iPod®. | A connector cable is not correctly connected, or the iPod® does not correctly operate. | Reconnect the connector cable again. If the system does not recognize the iPod® after performing this procedure above, reset the iPod®. |
| The iPod® that is to be connected is not compatible with the system. | Check the iPod® model and firmware versions available for the system. | |
| The connected USB cable is not compatible with the system. | Replace the USB cable if the system still does not recognize the iPod® after reconnecting the cable properly a number of times. |
Apple, iPhone®, iPod®, and iPod touch® are trademarks of Apple Inc., registered in the U.S. and other countries.
USB MEMORY DEVICE
| Symptom | Possible cause | Possible solution |
|---|---|---|
| The system does not recognize a USB device. | A USB extension cable is used. | Do not use a USB extension cable. |
| A USB hub is used. | Do not use a USB hub. |
Bluetooth® AUDIO
| Symptom | Possible cause | Possible solution |
|---|---|---|
| Music cannot be played back. | The system is not set to the Bluetooth® audio mode. | Select the Bluetooth® audio mode on the audio source selection screen. |
| Audio operation cannot be performed. | A Bluetooth® audio device that does not support audio operations is in use. | Use a device compatible with the system. |
| An error occurs when connecting to a Bluetooth® audio profile. | Turn the power source of the Bluetooth® audio player off and on, and then resume connection with the system. |
Bluetooth® is a trademark owned by Bluetooth SIG, Inc. and licensed to Robert Bosch GmbH.
Bluetooth® HANDS-FREE PHONE SYSTEM
| Symptom | Possible cause | Possible solution |
|---|---|---|
| A cellular phone cannot be registered. | The cellular phone is not compatible with the in-vehicle hands-free phone system. | Use a cellular phone compatible with the system. |
| Registration of the cellular phone has been performed incorrectly. | Check the registration procedure, and then register the cellular phone again. | |
| A cellular phone cannot be connected or is disconnected after the registration is completed. | The Bluetooth® setting of the in-vehicle hands-free phone system is turned off. | Turn on the Bluetooth® setting of the system. |
| The Bluetooth® setting of the cellular phone is turned off. | Turn on the Bluetooth® setting of the cellular phone. | |
| The remaining battery level of the cellular phone is low. | Charge the battery of the cellular phone. | |
| The wireless Bluetooth® connection may be disrupted depending on the location of the cellular phone. | Do not place the cellular phone in an area surrounded by metal or far away from the inNissan Armada vehicle hands-free phone system. Do not place the cellular phone close to the seats or your body. | |
| Registration of the cellular phone is not completed. | Perform registration of the cellular phone. | |
| A call to a particular phone number fails. | If the system tries to make a call several times to the same phone number (for example: the party does not respond to the call, the party is out of the service area, or the call is abandoned before the party responds), the system may reject a request to make a call to the phone number. | Turn off the cellular phone and turn it on again to reset the connection. |
| The system does not recognize the connection of a cellular phone. The system does not receive or make a call. | The cellular phone is not compatible with the in-vehicle hands-free phone system. | Use a cellular phone compatible with the system. |
| The cellular phone is not connected. | Check the registration procedure, and then register the cellular phone again. | |
| The phone operation is limited by the functions (such as dial lock, etc.) of the registered cellular phone. | Remove any settings that are limiting use of the cellular phone, and then perform registration again. | |
| The other party cannot hear your voice. The other party can hear your voice, but it cracks or cuts out. | Mute function is enabled. | Verify mute function is disabled. |
| The cellular phone is not connected. | Check the registration procedure, and then register the cellular phone again. | |
| The fan speed of the heater/air conditioner is too fast. | Decrease the fan speed of the heater/air conditioner. | |
| The ambient noise level is excessive. (For example: heavy rain, construction sites, inside a tunnel, oncoming Nissan Armada vehicles, etc.) | Close the windows to shut out ambient noise. | |
| The noise generated by driving the vehicle is too loud. | Reduce the vehicle speed. | |
| The incoming voice volume is too loud/soft. | Adjust the volume using the steering wheel switch. | |
| The voice is cut out or noise is heard during a call. | The wireless Bluetooth® connection may be disrupted depending on the location of the cellular phone. | Do not place the cellular phone in an area surrounded by metal or far away from the inNissan Armada vehicle hands-free phone system. Do not place a cellular phone close to the seats or your body. |
| When a cellular phone is operated to make a call, the hands-free function becomes unavailable. | Some models of a cellular phone do not switch to the hands-free mode when they are operated to make a call. | This is not a malfunction. Make another call using the hands-free function. |
| The other party’s voice cannot be heard. | The volume level is set to the minimum. | The other party’s voice volume is adjusted by operating the steering switch. |
| There is no ringtone. | The volume level is set to the minimum. | Adjust the volume level. |
| A cellular phone is not connected. | Check the registration procedure, and then register the cellular phone again. | |
| Each volume level is different. | Each volume level is not adjusted properly. | Adjust each volume level properly. |
| The antenna display is different between the touch screen display and a cellular phone screen. Making or receiving a call is unavailable even though the antenna display shows that it is possible to do so. | The antenna display varies depending on the model of cellular phone. | This does not indicate a malfunction. The antenna display and remaining battery level shown on the touch screen display may be different from those shown on the cellular phone screen. Use them as a reference. |
| A voice cannot be heard clearly when using a cellular phone behind tall buildings. | Some structures such as tall buildings, etc. may cause irregular reflection of radio waves or completely shut out radio waves that are used for cellular phones. | Move to a place without tall buildings. |
| Noise is heard when using a cellular phone under/near areas of elevated railroads, high voltage electric power cables, traffic signals, neon billboards, etc. | Electromagnetic waves that are generated from radio devices may adversely affect the cellular phone. | This is not a malfunction. |
| Noise is heard in the sound from the audio system while using a cellular phone. | Radio waves that are generated from a cellular phone may adversely affect the sound from the audio system. | This is not a malfunction. |
| Sound skips or stutters. | The cellular phone may have turned on the wireless LAN (Wi-Fi). | Turn off the wireless LAN (Wi-Fi). |
| Phonebook cannot be downloaded. | An error occurred during the phone pairing process. | Please delete the Bluetooth® pairing information from both the cellular phone and vehicle system before registering it again. |
| Phone does not support phonebook download function. | Use a cellular phone compatible with the system. |
Bluetooth® is a trademark owned by Bluetooth SIG, Inc. and licensed to Robert Bosch GmbH.
Android Auto
| Symptom | Cause and Counter measure |
|---|---|
| Cannot start Android Auto though it is connected to the vehicle. | The USB cable is not connected to the USB connection port. Properly connect the USB cable to the USB connection port. |
| Delete Android phone on the devices list and reconnect it to the in-vehicle system. | |
| The connected device is not compatible with Android Auto. Check the compatibility requirements. | |
| Cannot use wireless Android Auto. | The wireless connection is not completed properly. Delete Android phone on the devices list and reconnect it to the in-vehicle system. |
| Android Auto performance decreases. For example, slow connectivity or slow application functionality. or An error message appears when trying to access features of Android Auto. A blank screen appears when trying to access maps. | Confirm you have a compatible Android phone, a cellular connection and an active data plan. |
| Use the Android phone OEM cable to connect your phone to the USB connection port. | |
| Phone’s performance or cellular connection. Disconnect and reconnect your phone. | |
| Phone’s performance or cellular connection error may have occurred. Cycle phone power off/on to restart. | |
| Cannot start voice operation using " |
Check that you are pushing and holding " |
Apple CarPlay®
| Symptom | Cause and Counter measure |
|---|---|
| Cannot start Apple CarPlay® though it is tethered to the vehicle. | The USB cable is not connected to the USB connection port. Properly connect the USB cable to the USB connection port. |
| Use an Apple LightningTM cable (Mfi certified) to connect your phone to the USB connection port and check the cable that is not broken. | |
| Apple CarPlay® setting is not active on your iPhone®. Turn on “CarPlay” on your iPhone®. | |
| The device is not compatible with Apple CarPlay®. Check the compatibility requirements. | |
| Siri® setting is not enabled on the phone. Turn on Siri® on your phone. | |
| Cannot use wireless Apple CarPlay®. | The wireless connection is not completed properly. Delete iPhone® on the devices list and reconnect it to the in-vehicle system. |
Apple CarPlay® performance decreases. For example, slow connectivity or slow application functionality. or An error message appears when trying to access features of Apple CarPlay®. A blank screen appears when trying to access maps. |
Confirm you have a compatible iPhone®, a cellular connection and an active data plan. |
| Use an Apple LightningTM cable (Mfi certified) to connect your phone to the USB connection port. | |
| Phone’s performance or cellular connection. Disconnect and reconnect your phone. | |
| Phone’s performance or cellular connection. Cycle phone power off/on to restart. | |
| Cannot access Siri® using < |
Check that you are pushing and holding < |
Apple, iPhone®, iPod®, and iPod touch® are trademarks of Apple Inc., registered in the U.S. and other countries.
Siri® is a trademark of Apple Inc., registered in the U.S. and other countries.
Amazon Alexa
| Symptom | Possible cause | Possible solution |
|---|---|---|
| The system does not speak. | The volume level is set to the minimum. | Adjust the volume using the steering switch. |
| Different voice recognition app starts. | Amazon Alexa is not set as the main voice recognition function. | Set Amazon Alexa as the main voice recognition function. |
Apple, iPhone®, iPod®, and iPod touch® are trademarks of Apple Inc., registered in the U.S. and other countries.
Bluetooth is a trademark owned by Bluetooth SIG, Inc. and licensed to Robert Bosch GmbH.
Siri® is a trademark of Apple Inc., registered in the U.S. and other countries.