Transmission & Driveline

Diagnosis and Repair Workflow

4steps
~24min
2/5difficulty
Done 0 of 4

Work Flow

DETAILED FLOW

INTERVIEW FROM THE CUSTOMER

>>

GO TO 2.

CHECK SYMPTOM

Reproduce the symptom that is indicated by the customer, based on the information from the customer obtained by interview. Also check that the symptom is not caused by fail-safe function. Refer to Fail-Safe.

>>

GO TO 3.

PERFORM SELF-DIAGNOSIS

With CONSULT

Perform self-diagnosis for “DIFFERENTIAL LOCK”.

Is any DTC detected?

YES>>

Record or print self-diagnosis results. GO TO 4.

NO>>

GO TO 6.

RECHECK SYMPTOM

With CONSULT

  1. Erase self-diagnostic results for “DIFFERENTIAL LOCK”.

  2. Perform DTC confirmation procedures for the error detected system.

Is any DTC detected?

YES>>

GO TO 5.

NO >>

Check harness and connectors based on the information obtained by interview. Refer to Intermittent Incident.

REPAIR OR REPLACE ERROR-DETECTED PARTS

  • Repair or replace error-detected parts.

  • Reconnect part or connector after repairing or replacing.

  • When DTC is detected, erase self-diagnostic results for “DIFFERENTIAL LOCK”.

>>

GO TO 7.

IDENTIFY ERROR-DETECTED SYSTEM BY SYMPTOM DIAGNOSIS

Estimate error-detected system based on symptom diagnosis and perform inspection.

Can the error-detected system be identified?

YES>>

GO TO 7.

NO >>

Check harness and connectors based on the information obtained by interview. Refer to Intermittent Incident.

FINAL CHECK

With CONSULT

  1. Check the reference value for differential lock control unit.

  2. Recheck the symptom and check that symptom is not reproduced on the same conditions.

Is the symptom reproduced?

YES>>

GO TO 3.

NO>>

INSPECTION END

Diagnostic Work Sheet

Description

  • In some cases, multiple conditions that appear simultaneously may cause a DTC to be detected.

Interview sheet sample

Interview sheet
Customer nameMR/MSRegistration numberInitial year registration
vehicle typeVIN
Storage dateEngineMileagekm ( Mile)
Symptom □Differential lock indicator lamp does not turn ON with differential lock mode switch ON.
□Differential lock indicator lamp flashes while driving.
□Noise □Vibration

□Others

( )
First occurrence □Recently □Others ( )
Frequency of occurrence □Always □Under a certain conditions of □Sometimes (time(s)/day)
Climate conditions □Irrelevant
Weather □Fine □Cloud □Rain □Snow □Others ( )
Temperature □Hot □Warm □Cool □Cold □Temperature [Approx. °C( °F)]
Relative humidity □High □Moderate □Low
Road conditions

□Urban area □Suburb area □High way

□Mounting road (uphill or down hill) □Rough road
Operation conditions, etc.

□Irrelevant

□When engine starts □During idling

□During driving □During acceleration □At constant speed driving

□During deceleration □During cornering (right curve or left curve)
Other conditions

Memo