Front Oil Seal
Exploded View

| Front output shaft | Front oil seal | Front case | |||
| Snap ring | Sprockets with chain | Snap ring | |||
| Rear case | |||||
| : Always replace after every disassembly. | |||||
| : N·m (kg-m, ft-lb) | |||||
| : Apply transfer fluid. | |||||
| : Apply Genuine Liquid Gasket, Loctite 598 or equivalent. | |||||
Removal and Installation
REMOVAL
Drain transfer fluid. Refer to Draining.
Remove transfer assembly from vehicle. Refer to Removal and Installation.
Remove the rear case mounting bolts
.

- : Tighten together with the bracket.
Remove the rear case
.

Remove the rear output shaft snap ring
.

Remove the sprockets with chain
from front case
.

Remove the front output shaft snap ring
.

Remove the front output shaft
from front case
.

Remove the front oil seal
form front case
.

INSTALLATION
Install front oil seal with a drift (A) (commercial service tool) within the dimension (L) shown as follows.

| L | : 1.7 – 2.3 mm (0.067 – 0.091 in) |
Install the front output shaft
to front case
.

Install the front output shaft snap ring
.

Install the sprockets with chain
to front case
.

Install the rear output shaft snap ring
.

Apply sealant to mating surface of rear case.

For applying sealant, refer to Exploded View.
Install the rear case
.

Tightening the rear case mounting bolts
to the specified torque. Refer to Exploded View.

- : Tightening the bolt with bracket.
Install transfer assembly. Refer to Removal and Installation.
Fill with new transfer fluid. Refer to Refilling.
Inspection
INSPECTION AFTER INSTALLATION
Check fluid leakage and the fluid level. Refer to Inspection.
ADJUSTMENT AFTER INSTALLATION
When transfer case component parts are removed, performe writing unit parameter. Refer to Description.