Transmission & Driveline

Unit Parameter Writing

3steps
~18min
2/5difficulty
Done 0 of 3

Description

After working the following, transfer unit parameter must be written to transfer control unit.

  • Transfer control unit replacing

  • Transfer assembly replacing

  • Transfer control actuator replacing

  • Transfer range position sensor replacing

  • Transfer case component parts disassembling

For the work procedure, refer to Work Procedure.

Work Procedure

UNIT CHARACTERISTIC VALUE CONFIRMATION

Confirm the 5-digit alphanumeric unit characteristic value written in the QR code pasted on the side or top of the transfer assembly.

: Side surface
: Top surface
>>

GO TO 2.

WRITING UNIT PARAMETER

With CONSULT

  1. Ignition switch ON.

  2. Select “Work support” in “AWD/4WD”.

  3. Perform “Unit parameter writing” to the CONSULT display.

>>

WORK END