Body Exterior, Doors, Roof & Vehicle Security

Glass Lid

~2min read

Exploded View

Refer to Exploded View.

Removal and Installation

REMOVAL

Tilt glass lid up.

Disengage side trim from glass lid.

Remove glass lid fixing screws .

Remove glass lid from vehicle.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

Adjustment

Rear moonroof glass Glass lid Roof panel

If the clearance and the surface height are out of specification, adjust them according to the procedures shown below.

Unit: mm [in]

PortionStandard
Roof panel – Rear moonroof glass – E Clearance

6.4 – 8.0

[0.252 – 0.315]
F Surface height

(−2.4) – (+1.0)

[(−0.094) – (+0.039)]
– G Clearance

6.1 – 8.3

[0.240 – 0.327]
H Surface height

(−2.4) – (+1.0)

[(−0.094) – (+0.039)]
Roof panel – Glass lid – I Clearance

6.4 – 8.0

[0.252 – 0.315]
J Surface height

(−2.4) – (+1.0)

[(−0.094) – (+0.039)]
– K Clearance

6.4 – 8.0

[0.252 – 0.315]
L Surface height

(−2.4) – (+1.0)

[(−0.094) – (+0.039)]

Loosen glass lid fixing screws.

Adjust the clearance of glass lid and roof panel according to the fitting standard dimension.

To prevent glass lid from moving after adjustment, first tighten the fixing screw of front left, and then tighten the screw of rear right.

Tighten remaining fixing screws, being careful to prevent glass lid from moving.

Tilt glass lid up and down several times to check that it moves smoothly.