Rear Moonroof Glass
Exploded View
Refer to Exploded View.
Removal and Installation
REMOVAL
Remove moonroof unit assembly. Refer to Removal and Installation.
Remove rear moonroof glass fixing screws
, and then remove rear moonroof glass.

Remove fixing clips, and then remove center reinforce frame from rear moonroof glass.

| : Clip |
INSTALLATION
Note the following items, and then install in the reverse order of removal.
Adjustment

| Rear moonroof glass | Glass lid | Roof panel |
If the clearance and the surface height are out of specification, adjust them according to the procedures shown below.
Unit: mm [in]
| Portion | Standard | |||
|---|---|---|---|---|
| Roof panel – Rear moonroof glass | E | Clearance | 6.4 – 8.0 [0.252 – 0.315] |
|
| F | Surface height | (−2.4) – (+1.0) [(−0.094) – (+0.039)] |
||
| G | Clearance | 6.1 – 8.3 [0.240 – 0.327] |
||
| H | Surface height | (−2.4) – (+1.0) [(−0.094) – (+0.039)] |
||
| Roof panel – Glass lid | I | Clearance | 6.4 – 8.0 [0.252 – 0.315] |
|
| J | Surface height | (−2.4) – (+1.0) [(−0.094) – (+0.039)] |
||
| K | Clearance | 6.4 – 8.0 [0.252 – 0.315] |
||
| L | Surface height | (−2.4) – (+1.0) [(−0.094) – (+0.039)] |
||
Loosen rear moonroof glass fixing screws.
Adjust the clearance of rear moonroof glass and roof panel according to the fitting standard dimension.
To prevent rear moonroof glass from moving after adjustment, first tighten the fixing screw of front left, and then tighten the fixing screw of rear right.
Tighten remaining fixing screws, being careful to prevent rear moonroof glass from moving.