Engine

Oil Cooler

~3min read
01020304050107N·mlb·ft
Tightening torque found on this page

Exploded View

Oil cooler O-ring Oil filter
Connector bolt Oil catch plate Clamp
Oil cooler hose 2 Oil cooler hose 3 Oil cooler pipe 2
Oil cooler hose 1 Oil cooler pipe 1
Comply with the installation procedure when tightening. Refer to Removal and Installation To A/T water hose A. Refer to Exploded View To A/T water hose B. Refer to Exploded View
Comply with the installation procedure when tightening. Refer to Removal and Installation
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Always replace after every disassembly.
: Indicates that the part is connected at points with same symbol in actual vehicle.

Removal and Installation

REMOVAL

Remove engine under cover, using a power tool (commercial service tool). Refer to Removal and Installation.

Drain engine oil. Refer to Draining.

Disconnect A/T fluid cooler hose and oil cooler hose 2 .

Loosen oil cooler mounting bolts in the reverse order of the figure and remove the oil cooler.

Remove O-ring from oil cooler .

INSTALLATION

Note the following, and install in the reverse order of removal.

Tighten oil cooler mounting bolts to the specified torque in the order shown in the figure.

: 10 N·m

Inspection

INSPECTION AFTER REMOVAL

Oil Cooler

Check oil cooler for cracks. Check oil cooler for clogging by blowing through engine coolant inlet. If necessary, replace oil cooler.

Relief Valve

Check relief valve with the following procedure.

  • Press steel ball of relief valve using a clean plastic stick. Check that valve moves smoothly and proper spring repulsion is felt.

  • Replace relief valve, if necessary, with the following procedure.

    • Remove the relief valve by prying using a screwdriver.

    • Press in the relief valve until it reaches a depth of 7 mm (0.28 in) from end surface of oil pan (upper) using approximately 10 mm (0.39 in) diameter drift.

INSPECTION AFTER INSTALLATION

Check the engine oil level and the engine coolant level and add engine oil and engine coolant. Refer to ENGINE COOLANT : Inspection and refer to Inspection.

Start the engine, and check there is no leakage of engine oil or engine coolant.

Stop the engine and wait for 10 minutes.

Check the engine oil level and the engine coolant level again. Refer to ENGINE COOLANT : Inspection and refer to Inspection.