Body Interior

Second Seatback

~2min read

Disassembly and Assembly

DISASSEMBLY

Remove armrest.Disengage fixing pawls using a remover tool (A), and then remove armrest cover.

: Pawl
Remove mounting bolt, and then remove armrest.

Remove inside and outside seat cushion finisher outer. Refer to Disassembly and Assembly.

Disengage fixing pawls using a remover tool (A), and then remove tether anchor finisher.

: Pawl

Disengage seatback trim fixing retainer .

Remove seatback lever unit.Apply protective tape (A) to prevent damage.

Disengage fixing pawl using a remover tool (A), and then remove seatback lever unit cap.
: Pawl
Remove seatback lever unit fixing screw .
Pull out seatback lever unit and seatback lever cable as a set according to order 1→2 indicated by arrows as shown in the figure.
Disconnect seatback lever cable fixing portions according to order 1→2 indicated by arrows as shown in the figure, and then remove seatback lever unit from seatback lever cable.

Open seatback trim fixing fasteners .

Remove headrest holders by raising it while pinching pawls from the bottom of headrest holders.

Disengage harness fixing clip of seatback, and then disconnect harness connector.

Remove seatback trim and pad as a set from seat frame assembly.

Remove hog rings, and then separate seatback trim and pad.

Remove seatback lever unit escutcheon.

ASSEMBLY

Note the following items, and then assemble in the reverse order of disassembly.