Second Seatback
Disassembly and Assembly
DISASSEMBLY
Remove inside and outside seat cushion finisher outer. Refer to Disassembly and Assembly.
Remove armrest (LH seat).Disengage fixing pawls using a remover tool (A), and then remove armrest hinge cover RH.

| : Pawl |


| : Pawl | |
| : vehicle front |
Disengage fixing pawls using a remover tool (A), and then remove armrest hinge cover LH (LH seat).

| : Pawl |
Disengage fixing pawls, and then remove armrest hinge bracket LH (LH seat).

| : Pawl | |
| : vehicle front |
Disengage fixing pawls using a remover tool (A), and then remove tether anchor finisher.

| : Pawl |
Disengage seatback trim fixing retainer(s)
.
LH seat

RH seat

Remove seatback lever unit.Apply protective tape (A) to prevent damage.


| : Pawl |



Remove seat belt retractor cover (LH seat).Disengage fixing pawls using a remover tool (A), and then remove seat belt retractor cover cap.

| : Pawl |


| : Pawl |
Open seatback trim fixing fastener(s)
.
LH seat

RH seat

Remove headrest holders by raising it while pinching pawls from the bottom of headrest holders.

Remove center seatback trim assembly (LH seat).Disengage fixing clips and metal clip, and then remove center seatback panel.

| : Clip | |
| : Metal clip |
Disengage harness fixing clips of seat cushion, and then disconnect harness connectors.
Remove seatback trim and pad as a set from seat frame assembly.
LH seat

RH seat

Remove hog rings, and then separate seatback trim and pad.
Remove center seatback frame (LH seat).Disconnect seatback lever cable fixing portions according to numerical order 1→2 indicated by arrows as shown in the figure.


Remove center seatback hinge cover RH (LH seat).Apply protective tape (A) to prevent damage.


| : Pawl |
Remove center seatback hinge cover LH according to indicated by arrow as shown in the figure (LH seat).

Remove the following parts after removing seatback trim and pad from seat frame assembly.
Center seat belt guide.
Seat belt guide cap.
Seatback lever unit escutcheon.
ASSEMBLY
Note the following items, and then assemble in the reverse order of disassembly.