Brake Control System without ESP
C1110 ABS actuator and electric unit (control unit)
In this manual: Brake Control System without ESP
~1min read
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PRECONDITIONINGIf “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT-III.
1. Turn the ignition switch OFF to ON.
2. Perform self-diagnosis for “ABS”.
Is DTC “C1110” detected? YES >> Proceed to BRC-47, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK SELF-DIAGNOSIS RESULTSReplace ABS actuator and electric unit (control unit) even if other display than “C1110” is displayed in selfdiagnosis for “ABS”.
>> Replace ABS actuator and electric unit (control unit). Refer to BRC-90, "Removal and Installation".
Was this page helpful?