Charging System
Charging system preliminary inspection
In this manual: Charging System
~1min read
Inspection Procedure 1.CHECK BATTERY TERMINALS CONNECTION

Check if battery terminals are clean and tight.
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair battery terminals connection.
2.CHECK FUSECheck for blown fuse and fusible link.

Is the inspection result normal? YES >> GO TO 3.
NO >> Be sure to eliminate the cause of malfunction before installing new fuse.
3.CHECK “E” TERMINAL CONNECTION (ALTERNATOR GROUND)Check if “E” terminal (alternator ground) is clean and tight.
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair “E” terminal (alternator ground) connection.
4.CHECK DRIVE BELT TENSIONCheck drive belt tension. Refer to the following.
• HR16DE engine models: EM-154, "Checking" • MR16DDT engine models: EM-20, "Checking" • K9K engine models: EM-276, "Checking Drive Belts"
Is the inspection result normal? YES >> INSPECTION END
NO >> Repair as needed.
Was this page helpful?