Power Window Control System
Check anti-pinch function
In this manual: Power Window Control System
~1min read
Description
If any of the following operations are performed, the initialization is necessary for normal operation of antipinch function.
• Disconnection and connection of battery cable from negative terminal. • When power window main switch replaced. • Electric power supply to power window main switch or power window motor (driver side) is interrupted by blown fuse or disconnection and connection of the negative terminal of battery, etc. • Disconnection and connection of power window main switch harness connector. • Removal of power window motor (driver side) from regulator assembly. • Operation of regulator assembly as an independent unit. • Removal and installation of glass.• Removal and installation of door glass run.
Work Procedure
1.CHECK ANTI-PINCH FUNCTION 1. Fully open the door window. 2. Place a piece of wood near fully closed position. 3. Close door glass completely with AUTO-UP. 4. Check the following conditions. - Check that glass lowers for approximately 150 mm (5.9 in) without pinching piece of wood and stops.- Check that glass does not rise not when operating the power window main switch while lowering.
CAUTION:• Perform initial setting when AUTO-UP operation or anti-pinch function does not operate normally. • Check that AUTO-UP operates before inspection when system initialization is performed.
• Do not check with hands and other body parts because they may be pinched. Do not get pinched.
>> END
Was this page helpful?