Engine Cooling System MR16DDT
Cooling fan
In this manual: Engine Cooling System MR16DDT
~1min read
Exploded View

1. Fan motor
2. Fan shroud
3. Cooling fan
A. Apply on fan motor shaft
: N·m (kg-m, in-lb)
: Apply genuine high strength thread
locking sealant or equivalent.
Removal and Installation
REMOVAL
1. Drain engine coolant. Refer to CO-11, "Draining".
CAUTION:• Perform this step engine is cold.
• Never spill engine coolant on drive belt.
2. Remove engine cover. 3. Remove front bumper. Refer to EXT-12, "Exploded View". 4. Remove radiator core support upper. Refer to DLK-149, "MR16DDT : Exploded View". 5. Disconnect cooling fan harness connector. 6. Remove reservoir tank. Refer to CO-17, "Exploded View". 7. Remove radiator hose (upper). Refer to CO-17, "Exploded View".8. Remove cooling fan assembly.
CAUTION:Be careful not to damage or scratch on radiator core when removing.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:Only use genuine parts for fan shroud mounting bolt and observe the specified torque (to prevent radiator from being damaged). NOTE:
Cooling fan is controlled by ECM. For details, Refer to EC-774, "Component Function Check".
Disassembly and Assembly
DISASSEMBLY
1. Remove cooling fan mounting nut, and then remove the cooling fan.2. Remove fan motor.
ASSEMBLY
Note the following, and assemble in the reverse order of disassembly.
• Apply genuine high strength thread locking sealant on fan motor shaft.
Inspection
Cooling Fan
Inspect cooling fan for crack or unusual bend.
• If anything is found, replace cooling fan.
Was this page helpful?