Door lock status indicator
Component Function Check
1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK IND” in “ACTIVE TEST” mode.3. Check that the function operates normally according to the following conditions.

Is the inspection result normal? YES >> Door lock status indicator is OK.
NO >> Refer to DLK-83, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DOOR LOCK STATUS INDICATOR INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect door lock status indicator connector.3. Check voltage between door lock status indicator harness connector and ground.

Is the inspection result normal? YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK DOOR LOCK STATUS INDICATOR CIRCUIT 1. Disconnect BCM connector.2. Check continuity between BCM harness connector and door lock status indicator harness connector.

3. Check continuity between BCM harness connector and ground.

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation".
NO >> Repair or replace harness.
3.CHECK DOOR LOCK STATUS INDICATOR GROUNDCheck continuity between door lock status indicator harness connector and ground.

Is the inspection result normal? YES >> Replace door lock status indicator.
NO >> Repair or replace harness.