Driveline rear final drive: RTVS
Electric controlled coupling oil seal
In this manual: Driveline rear final drive: RTVS
~1min read
Exploded View

1. Rear final drive assembly 2. Electric controlled coupling oil seal
A. Oil seal lip
disassembly.
: Apply multi purpose grease
: Apply gear oil.
Removal and Installation
REMOVAL
1. Remove rear drive shafts. Refer to RAX-17, "Removal and Installation".2. Remove electric controlled coupling oil seals from electric controlled coupling, using a suitable tool.
CAUTION:Never damage electric controlled coupling.

INSTALLATION
1. Install electric controlled coupling oil seals to electric controlled coupling, using the drift (A) (SST: KV38109700).
NOTE:
The use of the special service tool satisfies the mounting dimensions.
• Never reuse oil seals. • When installing, never incline oil seals.
• Apply multi-purpose grease onto oil seal lips, and gear oil onto the circumference of oil seal.

2. Install rear drive shafts. Refer to RAX-17, "Removal and Installation".
3. When oil leaks while removing, check oil level after the installation. Refer to DLN-132, "Inspection".
Was this page helpful?