Insufficient cooling
Description
Symptom
• Insufficient cooling
• No cool air comes out. (Air flow volume is normal.)
Diagnosis Procedure
NOTE:
Perform self-diagnoses with CONSULT-III before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis.
6. Check that A/C indicator turns OFF. Check that compressor stops.
Is the inspection result normal? YES >> GO TO 2.
NO >> Perform diagnosis of “COMPRESSOR DOSE NOT OPERATE” in “SYMPTOM DIAGNOSIS”.
Refer to HAC-89, "Diagnosis Procedure".
2.CHECK DRIVE BELTCheck tension of drive belt. Refer to EM-20, "Checking".
Is the inspection result normal? YES >> GO TO 3.
NO >> Adjust or replace drive belt depending on the inspection results.
3.CHECK REFRIGERANT CYCLE PRESSUREConnect recovery/recycling recharging equipment to the vehicle and perform pressure inspection with gauge.
Refer to HA-83, "Symptom Table".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace parts depending on the inspection results.
4.CHECK AIR LEAKAGE FROM EACH DUCTCheck duct and nozzle, etc. of the air conditioning system for leakage.
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace parts depending on the inspection results.
5.CHECK AMBIENT TEMPERATURE DISPLAYCheck that there is not much difference between actual ambient temperature and indicated temperature on information display in combination meter.
Is the inspection result normal? YES >> GO TO 6.
NO >> Perform diagnosis for the A/C auto amp. connection recognition signal circuit. Refer to MWI-62, "Diagnosis Procedure".
6.CHECK SETTING OF TEMPERATURE SETTING TRIMMER 1. Check setting value of temperature setting trimmer. Refer to HAC-48, "Temperature Setting Trimmer".2. Check that temperature setting trimmer is set to “+ direction”.
NOTE:
The control temperature can be set with the setting of the temperature setting trimmer.
3. Set difference between the set temperature and control temperature to “0”.
Is inspection result normal? YES >> INSPECTION END
NO >> Replace A/C auto amp. Refer to HAC-91, "Removal and Installation".