Insufficient heating
Description
Symptom
• Insufficient heating
• No warm air comes out. (Air flow volume is normal.)
Diagnosis Procedure
NOTE:
Perform self-diagnoses with CONSULT-III before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis.
3. Check water flow sounds of the engine coolant. Refer to CO-12, "Refilling".
Is the inspection result normal? YES >> GO TO 2.
NO >> Refill engine coolant and repair or replace the parts depending on the inspection results.
2.CHECK HEATER HOSECheck installation of heater hose by visually or touching.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace parts depending on the inspection results.
3.CHECK HEATER CORE 1. Check temperature of inlet hose and outlet hose of heater core.2. Check that inlet side of heater core is hot and the outlet side is slightly lower than/almost equal to the inlet side.
Is the inspection result normal?YES >> GO TO 4.
NO >> Replace heater core. Refer to HA-116, "HEATER CORE : Removal and Installation".
4.CHECK AIR LEAKAGE FROM EACH DUCTCheck duct and nozzle, etc. of the air conditioning system for air leakage.
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace parts depending on the inspection results.
5.CHECK SETTING OF TEMPERATURE SETTING TRIMMER 1. Check setting value of temperature setting trimmer. Refer to HAC-48, "Temperature Setting Trimmer".2. Check that temperature setting trimmer is set to “− direction”.
NOTE:
The control temperature can be set by the temperature setting trimmer.
3. Set difference between the set temperature and control temperature to “0”.
Are the symptoms solved? YES >> INSPECTION END
NO >> Replace A/C auto amp. Refer to HAC-91, "Removal and Installation".