Brake Control System with ESP
Sensor rotor
In this manual: Brake Control System with ESP
~1min read
Front sensor rotor : Removal and Installatio
REMOVAL
Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled.
• MR16DDT: Refer to FAX-11, "Removal and Installation". • HR16DE: Refer to FAX-43, "Removal and Installation".• K9K: Refer to FAX-68, "Removal and Installation".
INSTALLATION
Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled.
• MR16DDT: Refer to FAX-11, "Removal and Installation". • HR16DE: Refer to FAX-43, "Removal and Installation".• K9K: Refer to FAX-68, "Removal and Installation".
Rear sensor rotor : Removal and Installation
REMOVAL
2WD
Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled. Refer to RAX-5, "Removal and Installation".
4WD
1. Remove drive shaft. Refer to RAX-17, "Removal and Installation".2. Remove sensor rotor from drive shaft. Refer to RAX-21, "FINAL DRIVE SIDE : Disassembly and Assembly".
INSTALLATION
Note the following, and install in the reverse order of the removal.
• Never reuse sensor rotor. (4WD)
Was this page helpful?