Heater & Air Conditioning Control System Type 3
Thermo control amplifier
In this manual: Heater & Air Conditioning Control System Type 3
~1min read
Removal and Installation
• Replace O-ring with new one. Then apply compressor oil to them when installing. • When install the thermo control amp., set the same position before replacement. • When remove the thermo control amp., never turn the bracket which is equipped the top of the thermo control amp.
REMOVAL
1. Remove evaporator. Refer to HA-115, "EVAPORATOR : Removal and Installation".2. Remove thermo control amp. from evaporator.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:• Replace O-ring with new one. Then apply compressor oil to them when installing. • When install the thermo control amp., set the same position before replacement. • When remove the thermo control amp., never turn the bracket which is equipped the top of the thermo control amp.
• Check for the leakages when recharging refrigerant. Refer to HA-74, "Leak Test".
Was this page helpful?