Transverse link
Exploded View

1. Front suspension member 2. Transverse link
disassembly.
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVAL
1. Remove tires. Refer to WT-7, "Removal and Installation".2. Remove transverse link from steering knuckle.
• MR16DDT: Refer to FAX-11, "Removal and Installation". • HR16DE: Refer to FAX-43, "Removal and Installation".• K9K: Refer to FAX-68, "Removal and Installation".
3. Remove transverse link from suspension member.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Never reuse transverse link mounting nut. • Perform final tightening of bolts and nuts at the vehicle installation position (rubber bushing), under unladen conditions with tires on level ground.• Perform inspection after installation. Refer to FSU-14, "Inspection".
Inspection
INSPECTION AFTER REMOVAL
Check the following items, and replace the parts if necessary.
Transverse Link• Transverse link and bushing for deformation, cracks or damage.
• Ball joint boot for cracks or other damage, and also for grease leakage.
Swing Torque1. Manually move ball stud to confirm it moves smoothly with no binding. 2. Move ball stud at least ten times by hand to check for smooth movement.
3. Hook a spring balance (A) at cutout on ball stud (B). Confirm spring balance measurement value is within specifications when ball stud begins moving.
Swing torque : Refer to FSU-22, "Ball Joint".Measurement on spring balance : Refer to FSU-22, "Ball Joint"
• If swing torque exceeds standard range, replace transverse link assembly.

Axial End Play
1. Move ball stud at least ten times by hand to check for smooth movement.
2. Move tip of ball stud in axial direction to check for looseness.
Axial end play : Refer to FSU-22, "Ball Joint".
• If axial end play exceeds the standard value, replace transverse link assembly.
INSPECTION AFTER INSTALLATION
Check wheel alignment. Refer to FSU-7, "Inspection".