Electrical & Power Control

Additional Service When Replacing Can Gateway. 3ch Can Gateway

4steps
~24min
2/5difficulty
Done 0 of 4
Description

For work procedure, refer to Work Procedure.

BEFORE REPLACEMENT

When replacing 3CH CAN gateway, save or print current vehicle specification (Type ID) with CONSULT configuration before replacement.

AFTER REPLACEMENT

  • When replacing 3CH CAN gateway, you must perform “Read / Write Configuration” or “Manual Configuration” with CONSULT.

  • Complete the procedure of “Read / Write Configuration” or “Manual Configuration” in order.

  • If incorrect “Read / Write Configuration” or “Manual Configuration”, incidents might occur.

  • Never perform “Read / Write Configuration” or “Manual Configuration” except for new 3CH CAN gateway.

Work Procedure

SAVING VEHICLE SPECIFICATION

CONSULT Configuration

Perform “Before Replace ECU” of “Read / Write Configuration” to save or print current Nissan Murano vehicle specification (Type ID). Refer to Work Procedure (Before Replacement).

>>

GO TO 2.

REPLACE 3CH CAN GATEWAY

Replace 3CH CAN gateway. Refer to Removal and Installation.

>>

GO TO 3.

WRITING Nissan Murano Vehicle SPECIFICATION

CONSULT Configuration

Perform “After Replace ECU” of “Read / Write Configuration” or “Manual Configuration” to write Nissan Murano vehicle specification (Type ID). Refer to Work Procedure (After Replacement).

>>

GO TO 4.

CHECK ALL ECU SELF-DIAGNOSIS RESULTS

  1. Erase all ECU self-diagnosis results using CONSULT.

  2. Turn the ignition switch OFF.

  3. Turn the ignition switch ON and wait for 2 seconds or more.

  4. Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.

>>

WORK END