Brakes

Adjustment of Steering Angle Sensor Neutral Position

6steps
~36min
3/5difficulty
Done 0 of 6
Description

Refer to the table below to determine if adjustment of steering angle sensor neutral position is required.

×: Required –: Not required

Situation Adjustment of steering angle sensor neutral position
Removing/Installing ABS actuator and electric unit (control unit) —
Replacing ABS actuator and electric unit (control unit) ×
Removing/Installing steering angle sensor ×
Replacing steering angle sensor ×
Removing/Installing steering components ×
Replacing steering components ×
Removing/Installing suspension components —
Replacing suspension components ×
Changing tires to new ones ×
Tire rotation —
Adjusting wheel alignment ×
Work Procedure

ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

(Adjustment cannot be done without CONSULT).

ALIGN THE VEHICLE STATUS

Stop vehicle with front wheels in straight-ahead position.

>>

GO TO 2.

PERFORM THE NEUTRAL POSITION ADJUSTMENT FOR THE STEERING ANGLE SENSOR

CONSULT

  1. Select “ST ANGLE SENSOR ADJUSTMENT” in “Work support” mode of "ABS".

  2. Select “Start”.

  3. After approximately 10 seconds, select “End”.

  4. Ignition switch OFF then place it ON again.

>>

GO TO 3.

CHECK DATA MONITOR

CONSULT

  1. Run Nissan Murano vehicle with front wheels in straight-ahead position then stop.

  2. Select “Data Monitor”. Then make sure “STR ANGLE SIG” is within 0±3.5°.

Is the steering angle within the specified range?

YES>>

GO TO 4.

NO>>

Perform the neutral position adjustment for the steering angle sensor again GO TO 1.

ERASE THE SELF DIAGNOSTIC RESULT MEMORY

CONSULT

Erase the “Self Diagnostic Result” memory of the ABS actuator and electric unit (control unit) and ECM.

  • ABS actuator and electric unit (control unit): Refer to CONSULT Function.

  • ECM: Refer to CONSULT Function.

Are the memories erased?

YES>>

Inspection End.

NO>>

Check the items indicated by the “Self Diagnostic Result”.