Brakes

Configuration [abs Actuator and Electric Unit (control Unit)]

13steps
~78min
3/5difficulty
Done 0 of 13
Work Procedure

CHECK TYPE ID (1)

CONSULT

  1. Select “ECU Identification” mode of “ABS”.

  2. Write down “ECU PART NUMBER” displayed on the CONSULT screen. This is the ABS actuator and electric unit (control unit) “Type ID”.

Is “Type ID” displayed?

YES>>

When replacing ABS actuator and electric unit (control unit): GO TO 3.

YES>>

When re-configuring existing ABS actuator and electric unit (control unit): GO TO 4.

NO>>

GO TO 2.

CHECK TYPE ID (2)

  1. Use FAST (service parts catalog) to search ABS actuator and electric unit (control unit) of the applicable Nissan Murano vehicle and find “Type ID”.

  2. Write down “Type ID”.

>>
  • When replacing ABS actuator and electric unit (control unit): GO TO 3.

  • When re-configuring existing ABS actuator and electric unit (control unit): GO TO 4.

REPLACE ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Replace ABS actuator and electric unit (control unit). Refer to Removal and Installation.

  • Air bleeding

  • Adjustment of steering angle sensor neutral position

  • Calibration of decel G sensor

>>

GO TO 4.

WRITE CONFIGURATION

CONSULT

  1. Select “Manual Configuration”.

  2. Select the “Type ID” found using CONSULT “ECU Identification” or FAST (service parts catalog) to write the “Type ID” into the ABS actuator and electric unit (control unit).

>>

GO TO 5.

VERIFY TYPE ID

Compare the “Type ID” written into the ABS actuator and electric unit (control unit) with the one found using CONSULT “ECU Identification” or FAST (service parts catalog) to confirm they match.

Do Type IDs match?

YES>>

GO TO 6.

NO>>

GO TO 4.

CHECK VDC WARNING LAMP

  1. Ignition switch OFF.

  2. Ignition switch ON and check that the VDC warning lamp turns OFF after staying illuminated for approximately two seconds.

Is the inspection result normal?

YES>>

GO TO 7.

NO>>

Perform self-diagnosis of “ABS”. Refer to CONSULT Function.

PERFORM SUPPLEMENTARY WORK

  1. Perform air bleeding. Refer to Bleeding Brake System.

  2. Perform adjustment of steering angle sensor neutral position. Refer to Work Procedure.

  3. Perform calibration of decel G sensor. Refer to Work Procedure.

  4. Perform self-diagnosis of all systems.

  5. Erase self-diagnosis results.

>>

Work End.