Body Exterior, Doors, Roof & Vehicle Security

Calibration of Automatic Back Door Position Information

4steps
~24min
2/5difficulty
Done 0 of 4
Description

When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system:

  • After removing and installing or replacing back door assembly

  • After removing and installing or replacing spindle unit

  • After adjustment or position change of the back door hinges or striker

Work Procedure

STEP 1

Fully close the back door manually.

>>

GO TO 2.

STEP 2

CONSULT

  1. Select “RESET AUTO BACK DOOR STATUS” in “Work support” mode of “AUTO BACK DOOR”.

  2. Select “START” to erase automatic back door position information.

>>

GO TO 3.

STEP 3

Operate back door opener switch and perform automatic open operation.

>>

GO TO 4.

STEP 4

  1. The back door fully opens.

  2. Check that automatic back door warning buzzer sounds normally.

Do automatic back door warning buzzer sound normally?

YES>>

GO TO 5.

NO>>

GO TO 1.

STEP 5

Fully close the back door.

>>

Inspection End.