Vehicle specification needs to be written with CONSULT because it is not written after replacing BCM.
Configuration has three functions as follows:
Function
Description
"Before Replace ECU"
Reads the Nissan Murano vehicle configuration of current BCM.
Saves the read vehicle configuration.
"After Replace ECU"
Writes the Nissan Murano vehicle configuration with manual selection.
"Select Saved Data List"
Writes the Nissan Murano vehicle configuration with saved data.
Work Procedure
WRITING MODE SELECTION
CONSULT
Select “Reprogramming, Configuration” mode of "BCM".
When writing saved data>>
GO TO 2.
When writing manually>>
GO TO 3.
PERFORM “SAVED DATA LIST”
CONSULT
Automatically “Operation Log Selection” window will display if “Before Replace ECU” was performed. Select applicable file from the “Save Data List” and press “Confirm”.
>>
Work End.
PERFORM “AFTER REPLACE ECU” OR “MANUAL CONFIGURATION”
CONSULT
Select “After Replace ECU” or “Manual Configuration”.
Identify the correct model and configuration list. Refer to Configuration List.
Confirm and/or change setting value for each item.
Select “Next”.
When "Completed", select "End".
>>
GO TO 4.
OPERATION CHECK
Confirm that each function controlled by BCM operates normally.
>>
Work End.
Configuration List
SETTING ITEM
NOTE
Items
Setting value
COMBI_SW_TYPE
MODE1 ⇔ MODE2
MODE1: With OFF position for daytime running lamps
MODE2: Without OFF position for daytime running lamps